Stain Resistant Texture

1 SUBSTRATE PREPARATION

Substrates must be sound, dry, clean and as smooth as possible. Tape off adjacent surfaces with the proper low tack tape. Patch serious imperfections, deficiencies, etc., with Boero Water-Resistant Gypsum Powder.
Application of Basecoat
Apply 2 coats of eg-shel paint in a similar color to the Boero Stain Resistant Texture color.

2 APPLICATION OF STAIN RESISTANT TEXTURE

The Boero Stain Resistant Texture is an Elastomeric Fine Stucco that can be applied using a microfiber roller, then Back-Troweled, Back-Brushed, Embossed with Texture Rollers, etc., or Troweled directly to the surface. Product is ready to use 1 or 2 coats are advised. (2 coats for full coverage, with “Smooth Effect” as the 1st layer).
Smooth Effect, Roll & Back-Trowel: Using a microfiber mini roller in corners and edges and a 9” microfiber roller in the large areas, apply the Boero Stain Resistant Texture in random rolled directions (up, down and diagonally, creating random “curving X’s”). Immediately “Back-Trowel” randomly using a Boero Stainless-Steel Flex Trowel to create a smooth, random pattern.(This layer can be used as the 1st coat in a 2-coat finish).

3 EFFECT

Criss Cross Pattern & Textures: Using a microfiber mini roller in corners and edges and a 9” microfiber roller in the large areas, apply the Boero Stain Resistant Texture in random rolled directions (up, down and diagonally, creating random “curving X’s”). Immediately “Back-Trowel” randomly using a Boero Stainless-Steel Flex Trowel to create the desired random pattern.
Textile Effect, Roll & Back Brush: Using a microfiber mini roller in corners and edges and a 9” microfiber roller in the large areas, apply the Boero Stain Resistant Texture in vertical directions. Immediately Back-Brush through the product in vertical for a Striae effect. Immediately Back-Brush through the product in vertical and then randomly in horizontal direction for a Textile Effect.

TECHNICAL INFORMATION

COVERAGE: 100-150 sq ft / U.S. gal for each layer. (depending on the substrate and thickness applied).
DILUTION: Ready for use.
DRYING (at 70°F and 65% H.R.):
Touch dry: 1-2 hours.
For re-coating: 6-8 hours.
Fully dry: 24 hours.
TOOLS: Roller, brush, Boero Stainless-Steel Flex Trowel.
TOOLS CLEANING: Clean tools immediately after use with water.
STORAGE TEMPERATURE: Keep the product in a cool place and do not allow to freeze. Do not apply at temperatures below 40°F.
V.O.C.: Max. 100 g/L (0.83 lbs/gal)